Recent content by mutley racers

  1. M

    Viessmann external flue run conundrum

    Atag let you go for the 600mm clearance away as well on P.
  2. M

    Viessmann external flue run conundrum

    As in Z in this image here. Quite annoying having to type a lot of characters to post.
  3. M

    Viessmann external flue run conundrum

    Yes, vailliant are 600mm to nearest corner of the openable window..
  4. M

    Viessmann external flue run conundrum

    Hi Shaun. That's weird as I have just been looking on the baxi flue solutions. Maybe they made a mistake...
  5. M

    Viessmann external flue run conundrum

    Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
  6. M

    Worcester 30i ionisation fault

    Hi all. I hope you are well. Need some advice on this boiler and fault. E229. Went there and condensate was totally blocked so cleaned it and still not fixed. Then serviced it and still got the fault. Called up worcester and one says its the gas valve as it is making a 3 whoosing noises while...
  7. M

    New part L regulations for plumbers.

    Thanks all. Good to know as it would be a rather expensive boiler replacement.
  8. M

    New part L regulations for plumbers.

    Hi all. Just need to clear my head around these changes. I am guessing we do not need to put in new radiators when just replacing a boiler?
  9. M

    Sealant for external flue run.

    Hi all. Got to run a Vailliant flue externally and been told by vailliant I need a heat resistant flexible silicone. Can anyone recommend which silicone to go for? Cheers
  10. M

    Hole size for countertop...

    Then it's really hard to be 100% sure it's not leaking.
  11. M

    Hole size for countertop...

    Threy are all leaking!
  12. M

    Hole size for countertop...

    Good point. Ahold be ok with a diamond holesaw at an angle though a?
  13. M

    Hole size for countertop...

    I need to take the lot out and cut the holes so that the hole waste and flange nut fit into the countertop? Rather than fix the threaded waste through the countertop and tighten the back nut onto the bottom of the countertop. Hope that makes sense. Basically, what size is the back nut to a 11/4...
  14. M

    Hole size for countertop...

    Morning all. What size diamond holesaw do you use for drilling the hole in a quartz countertop for a basin waste to go through? I have a house where they installed all the basins wastes with the nut and washer tightened onto the bottom of the worktop and not the bottom of the basin. Hope that...
  15. M

    Tap identification needed...

    It does look like the cartridge. Out of stock. Look like £80. Wow

Newest Plumbing Threads

Back
Top