titanium

  1. abc_plumb

    E133 Error Potterton Titanium 24

    Hiya fellow gas engineer. Need some help on this boiler fault. Went out to this E133 Error on a Potterton Titanium 24 (GC: 47-393-39) I checked the inlet standing pressure which was at 25mb. Boiler attempts to fire and the pressure drops by 1mb but the gas valve doesn't open. Checked the black...
  2. C

    Pressure too high on Potterton Titanium Boiler

    Last night I noticed the Boiler on E1. After a few times in the past having this issue and being advised on how to re-pressure the boiler, I pressured it to just under 2 - Boiler working again! This morning I came down to find out the under floor heating hadn't heated up the kitchen as much it...
  3. M

    Baxi combi 80d to potterton titanium

    Hi all I want to change my son's Baxi combi 80e to a potterton titanium I think the back mounting plates are the same but the potterton has an offset flue Baxi seem to make an offset flue adaptor and was wondering if anyone as done this change the Baxi is 15 years old and been relatively fault...
  4. B

    Immersion heater: copper, Incoloy or titanium element?

    Hi, I'm replacing a 14" copper immersion heater installed into a Fortic hot water cylinder. The heater failed after just three years. Hoping to get more life out of the next one, I've ordered an Incoloy, but am wondering whether to go for the titanium instead. It's only an extra couple of...
    • boilingpoint
    • Thread
    • america copper element heater immersion immersion heater incoloy tesla titanium usa
    • Replies: 7
    • Forum: USA Plumbers Advice
  5. E

    Baxi Titanium vs Baxi Platinum

    Hello, I have been quoted £2200 for a Baxi Titanium and £2600 for a Baxi Platinum combi install. As far as I know both have stainless steel heat exchangers. The only difference seems to be the warranty - seven years vs ten - is this correct or are there other differences I should be aware of ?
  6. S

    Prosource 4l Boiling Water Heater Titanium

    Boiler - Prosource Boiling Water Heater AEG GYB00416UT Product number - 945115307 Prosource - GYB00416UT Pressure Safety valve with t-piece, hose, bracket, 4 screws and tie wrap. Comes brand new in two boxes, no tap included. Installation and user manuals included. Sensible offers...
  7. K

    Potterton Titanium 33 boiler problem

    Hi, I hope you can help. I have a Potterton Titanium 33 combination boiler. I have had it for just over 4 years. It has just started to make a flushing and cracking sound when using the hot water tap. The central heating is currently turned off and the flow and return valve closed from the...
  8. G

    Potterton Titanium problem

    customer just been on phone saying when boiler is turned on it is constantly lighting for hot water when they arent calling for hot water, but if they ask for hot water it stops. if they ask for heating it will overide the hot water. any suggestions guys?
  9. B

    Need a robust immersion heater - direct hot water cylinder

    Hi guys, just wondering if you could tell me where I might be able to buy a more robust immersion heater for a direct hot water cylinder. Cuts does not have central heating or any other way to heat hw but has to change the immersion heater approx after 8 months
    • beesley121
    • Thread
    • copper cylinder direct heater heatrae hot hot water hot water cylinder immersion immersion heater titanium water
    • Replies: 5
    • Forum: Plumbing Jobs | The Job-board
  10. K

    potterton titanium commissioning with E1 68 fault

    Hi allI have installed a potterton titanium today and on commissioning the boiler the pump starts and the fan then it goes to fault e1 68 and I cannot find anything in manual to help me out.Any ideas would be appreciated thanks Neil
  11. K

    Potterton heatmax

    So seen it in pts with a half decent price. Coming with a clock and flue. To my inexperienced eyes it looks identical to a duo tec - the clock. I know baxi and potterton are all run by BDR Thermea so it makes seance I they are virtually the same and sold with different badges...
  12. L

    Potterton titanium 28 or 33 kw

    Hi further to my previous post http://www.ukplumbersforums.co.uk/central-heating-forum/39369-1st-big-job-help-please.html I now have another couple of questions. I'm changing an old floor standing boiler to a pot titanium and installing new rads. how would you flush the pipes?? was thinking...
  13. M

    Immersion heater....

    Can anyone suggest the best brand, metal type of Immersion heater... Having just explored online, seems so many different types... eurralloy, titanium, copper, incaloy the list goes on... Its a 27 inch Immersion... I want super fast, best quality.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock