Tiling Advice

One of new floor tile is making a random clicking noise

450 x 450 porcelain tiles were laid on the bathroom floor recently. One of the tile sometimes makes a clicking noise.

We have wooden floor in the bathroom and tiler put the Becker boards with screws and put some liquid/paint on Becker board for waterproof and then used adhesive for tiles.

I was wondering if only that one tile needs to be removed and then put it back with more adhesive?

One of new floor tile is making a...

 

Tilers Community Midnight Messages Whilst Drunk Send Shivers Down Manufacturers Spines

Woke up this morning to some abusive messages from Sam Hoffman of the Facebook Group Tilers Community.

Sam Hoffman of Hoffman Tiling and Bathrooms Limited, of which we have all company accounts and persons involved, sent abusive messages we assume whilst drunk on Friday evening. They regretted it instantly so we woke up to the following. ...

 

Best tile cutter

Hay there,
Need a new tile cutter 600 minimum, I’ve used one from topps tiles which was ok, but I need to upgrade that’s why I’m asking the professionals (you) for suggestions.

Best tile cutter for more information

You may reply to this message here.

 

Too thick to cut?

Not a full time tiler and questioning everything but..I need a wet saw to cut a lot of 45's in 20mm, 12" marble tile. Is the Sealey 180 a decent bench saw for a small but tricky job? Any other options anyone might suggest would be welcome.. thanks

Too thick to cut? for more information

You may reply to this message here.

 

Tile up to or undercut door frames / linings?

Hi, sorry if this is a silly question but I can't seem to find a definitive answer. I've got a lot of tiling to do in our self build and currently it's just the door linings in place, no architrave etc yet. Should the tiles be fitted up next to the door linings with a small expansion gap and then siliconed or should I cut the bottoms of the frames and slide the tiles underneath?

The latter would look better but isn't there the potential...

 

Skirting tile price

Hello one and all,
I have a 240m2 floor tiling job to price, including a tile upstand edged with tile trim, tiles 1m length, going into several rooms.

What i'm asking is if there is a standard linear metre rate, or base it on a day for estimated time taken.
I feel it needs to be a decent rate, as it mullers your back and big toe joints when doing them all day!

Thanks in advance,
Paul

Skirting tile price for more information

You may reply to this...

 

Some deals on Amazon for tools - Any good though?

Amazon.co.uk: : DIY & Tools ​

Online shopping for from a great selection at DIY & Tools Store.
www.amazon.co.uk

Seem to be some trade tools at good prices here, are they any good though?

Some deals on Amazon for tools - Any good though? for more information

You may reply to this message here.

 

Tilers Community

Tilers Community

...

 

Through the Looking Glass 1920s bathroom

This was such a fun yet stressful project. I had to reglaze most of the black trim tile due to the fact that they weren't finished on all sides.

Through the Looking Glass 1920s bathroom for more information

You may reply to this message here.

 

Plain White Gloss 397x247 tiles

Looking for white plain gloss 397x247 tiles made by British Ceramic Tiles company or any similar. The date was around 2010.

Plain White Gloss 397x247 tiles for more information

You may reply to this message here.

 

Beginner - how much pressure to apply to tiles when pressing in to adhesive on wall?

Most tutorials suggest 'pushing firmly'. How do you know how firmly, and how can you ensure that each tile is 'equally' pushed into adhesive, ensuring it's level?

Beginner - how much pressure to apply to tiles when pressing in to adhesive on wall? for more information

You may reply to this message here.

 

Hello

Hello

Hello for more information

You may reply to this message here.

 

Introduction

Hello all, My name is Bill. I have registered on the Tilers Forum in order to try
to locate some obsolete tiles and also to obtain some advice on tiling. Kind regards.

Introduction for more information

You may reply to this message here.

 

Trowel - with Mapei Standard Set Plus

Some adhesives give info (not seemingly Mapei). I think the Mapei Standard Set Plus would suit be well as a DIY'er.

How do I know what trowel type/size to use? Does it really matter?

I'll be fixing 60x30 ceramic wall tiles to Marmox boards.

Trowel - with Mapei Standard Set Plus for more information

You may reply to this message here.

 

Why do I have no hot water? Please help Discussion Thread

Why do I have no hot water? Please help Discussion Thread[/url]

Hi
About 8 years ago the valve under the sink burst. Major flood. They capped the hot water pipe to the washer and apparently replumbed everything g else. Since then I had very low hot water pressure in kitchen through a single faucet double tap style tap with two flexi hose under the sink. I complained a lot and I was told by council it was the tap. But they...

 

Water in both sinks are going down slow Discussion Thread

Water in both sinks are going down slow Discussion Thread[/url]

Hi All,

I just had a question about something I noticed. Since last week my dishwasher is not working and beeping three time. According to internet this means that it means theres water in the base of the dishwasher activating the flood switch.
Funny enough water my sinks both in the kitchen AND the bathroom are going down very slow.
I wonder if this is related...

 

Electric & Electrical | looking for 12v emergency led driver. Discussion Thread

Electric & Electrical | looking for 12v emergency led driver. Discussion Thread[/url]

looking for 12v emergency led driver.{/b}

Evening all,

I've recently done some emergency lighting testing at an office and several of the sign lights are in need of repairs.

One of the lights in particular is a 12v 3W LED strip. I've tried to source a driver and battery backup box directly from the manufacturer...

 

Electric & Electrical | Meaning of wire specs Discussion Thread

Electric & Electrical | Meaning of wire specs Discussion Thread[/url]

Meaning of wire specs{/b}

I want to replace a wire with an identical one, except longer. The text on the wire is: 300V XUANSHI C(UL) SJTO 105C FT1 4X0.824MM2(18AWG) E257497. I showed this to the guy at Home Depot, and he told me it meant 18 gauge (which I already knew), but couldn't provide any other information. I'd appreciate any help.

Click...

 

Ready mixed adhesive with 60x30 tiles - will it set?

Is the issue with ready mixed adhesive seemingly only recommended for 30x30 tiles max that it will not set at all giving required adhesion, or is it that it will take a longer (than the usual 24 hour) setting time?

Ready mixed adhesive with 60x30 tiles - will it set? for more information and to reply to this

This RSS Feed has posted this content from our UK Tiling Forum. Free advice on tiling tools, tiling...

 

1.2 x 1.2m large format tiles & Decoupling Mat?

Hi, I have 45m2 of 1.2 x 1.2 Mirage 9mm floor tiles to lay. Never done this size before. I’m planning to lay a decoupling mat prior - are there any recommendations? Some products say not suitable for large format or very small. I’d like to keep the total build up as low as possible as there’s only 16mm to the threshold of a sliding door, but obviously don’t want any issues. Will certainly end up slightly higher than that threshold I...

 

Johnson Tiles buyout completed Discussion Thread

This is the Johnson Tiles buyout completed Discussion Thread

The management buyout of Johnson Tiles has now been completed. The Stoke on Trent based ceramics factory will shut with the loss of 100 jobs. The deal takes the 123-year-old brand into private hands with all production outsourced. Here at Tilers Forums we feel for the 100+ staff as once again another once great British […]

Johnson Tiles buyout completed | Continue...