Bath waste - Google Drive
I have attached 3 photos ,the pipe with the white cap on is leaking when the bath drains,when I open it up it has the blue cap on shown in the picture ,if I remove that I side is a like a rubber seal/ grometwhich has a pin on the bottom that goes into a hole and can be...
The customer dosen't want to change the cast iron bath but it has rust around the plug waste hole. It dosent look good and is difficult to clean.
I've suggested touching up the bath with some repair enamel paint but now am not sure which product to use. Some of the product reviews are not good...
Hey guys, what type of bath waste/overflow kit has been the best for you, in terms of reliability and quality. The classic or the push button kind, are there brands to avoid and brands to use? I rather advice from the pros than reviews on sites and are mostly fake these days. Any help is...
Back at the beginning of September I had a leak underneath the bath that turned out to be the waste outflow so I had Dyno plumbing come and repair it, took a couple of hours as the bath panel had been tiled in by the previous owner so the plumber had to smash through it. Total cost was £220 and...
Hi, has anyone fitted one of these Geberit bath wastes before?
Geberit Bath Pop up Waste and Overflow : UK Bathrooms
I'm reading the installation instructions and it says "PVC push fit required - do not solvent weld"
I'll be having 40mm solvent weld piping running round to the bath - am I...
hi gents and girls.
I have a problem.
Bath waste water wont flow down the waste pipe. Bath backs up when taps running.
(this is a whole new bath refurb and no, grout and adhesive residue was not washed in to bath)
So far, Ive taken off the trap and examined the pipe work for sediment. (hair...
We are buying a Kaldewei (German) steel bath, which has 52mm outlet and waste holes. Kaldewei's own (hugely expensive) waste range looks a bit iffy for connecting to normal 40mm plumbing. Has anyone done this? How did you do it? Failing that, can anyone recommend a UK, 40mm waste that will...
There I am getting my bathroom replaced, when I find out just why my old bath was set so high off the floor. The branch to the soil stack stands about a foot off the ground.
It has the feel of lead, but on scratching with a key it has the hardness of iron. The house was built in the 60s, if...
Hi, i have a bath and toilet in close proximity, with the soil pipe horizontal (inc. required gradient) along the bathroom wall where it exits and eventually gets to the vertical soil stack.
Can i connect the 40mm waste pipe to the soil pipe, if so do i need a no return valve or anything? The...
Bath has a central plug hole with a pipe to wall and waste. Out of the blue it has started leaking from a joint downstream to the waste , - see green arrow in photo. It happens when unplugging the bath to drain for about 30 seconds and then stops. Could have been hit by vacuum cleaner recently....
Okay so I'm pretty good with DIY and have a good set of tools. Recently found water coming from under the bath every time I had one, left it too long and just decided to take the panel off to find the whole floor soaking and the bath waste pipe dripping. I don't have much knowledge but am I...
DIYwelshwoman
Thread
bathbathwaste
coming
fitting
leaking
pipe
wastewaste pipe
water
Hi fitting a slipper bath and need a unslotted waste 1 3/4" and unable to get one anywhere ?? any ideas it needs to be at least 80mm long to clear foot on bath . Can only see short versions . Got one but its only 40mm diameter so wont fit bath trap . Live in western Isles so everything has to...
When installing a bath wash that comes with a foam top washer, do you use this or throw it and use silicone? Also do most people put silicone on the bottom washer always?
Hi, Please can someone help me with this
I need to replace the popup waste on my bath. At the overfow end there is a chrome cap that rotates to make the popup operate. I was expecting to find a grub screw at the bottom of this cap which I could unscrew to remove the cap but there is no screw I...
Hi, Please can someone help me with this
I need to replace the popup waste on my bath. At the overfow end there is a chrome cap that rotates to make the popup operate. I was expecting to find a grub screw at the bottom of this cap which I could unscrew to remove the cap but there is no screw...
Alright guys?
I don't really do any plumbing work but my mate has a leak from the bath waste. I've tried to remove it all to try and reseal but the plug part of the waste is stuck solid with silicone and the bath is quite thin so don't want to put too much force on it and end up breaking the...
Hello i am replacing an old bath with a new P bath.
The old one has the wast on the right but the new one is on the left it has to be this side for the shower and the run is all most
Horizontal. Can it be pumped up hill.
In first floor flat (built 1980's) the bath waste pipe goes through the wall very close to where the soil stack is. It's all behind boxed in work.
Is there any way to tell if the bath waste is connected to the stack or the pipe goes out to a gully without having to rip up a lot of boxing in...
Hi guys been a long time but got something I can't quite figure out...
basically its its a slow running bath waste but can't figure out why as it doesn't do it all the time.
This is a long and boring post but trying to give as much info so you know what's already been tried. Sorry!!!
Quick...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.