Done something I've never done before.
Got up and shaved a 54 year old face!
Happy Birthday to me, Happy Birthday to me.
And Daley Thompson + July 30 Birthdays - Celebrities Born July 30 | Famous Birthday
Hi,
Just wondering on average how long it takes for your certificates to be sent for you to then register? they say up to 6 weeks!! already had to pass on 10 landlords so as you could imagen could do with it coming soon.
Thanks all.
Rob.
Hi this is my first post so I'm hoping i can get some feed back I'm fitting 15mm Instinct Thermostaic Mixer Valves and continually having a problem with water at the P.O.U. basicly drip at the start and after a while i get full bore checked filters on TMV and washers on taps all seem OK any info...
Hi ladies and gentlemen,
Been asked by the owner of a first floor flat to fit an outside tap, they own the garden and there currently isn't a tap in the garden.
Haven't seen the property yet but told the kitchen faces the garden.
Firstly I think they should get permission from the people below...
RAW85
Thread
first
flat
floor
garden
outside
outside tap
property
tap
water
I'm going to look at a job on Thursday but I wanted to run it past you first.
They're friends of my girlfriend and have said they've already had a plumber out who stated he couldn't fix it as he'd end up cracking the granite worktop.
The tap body is loose, the whole tap turns. I'm thinking the...
For the past one week, someone has been trying desperately to get me to have first call for all plumbing jobs in Croydon WTF?
When he rang, I asked what he was selling? Nothing he said laughing a lot at the idea??? Then he proceeded to tell me that for a one off fee, I will always be the...
Ten this morning. Wanting some pipes moving as getting a new hardwood floor. Said I would look on Wednesday. No, no, no, they are fitting it now. I need you to be here before 12. Bye bye.
Hi guys fitting my first boiler (gas safe) and sooooo silly question time. BTW only registered through a company yesterday pm. With regards to air vents on boiler pipework with a pressurised system.... are they necessary. the plumber I worked for alwys put them in but with the layout of the...
Hi guys, I have this water temp issue which has lasted for years. Basically what happened is the shower water temp has never been stable in the bathroom, when we turn on the shower water it comes out hot as expected but after a few seconds it becomes ice cold, and then it becomes hot again. This...
Hi there,
Have to cut into cast iron stack tomorrow to connect toilet tee. Can't replace everything above it in plastic so need to use a fernco coupling on the top cut. Was wondering if instead of doing the same on the bottom cut you can just pull the male part of the cast iron pipe up (it's...
Went to a multi-dwelling property the other day to carry out a service, The gas meter is in a purpose built room which houses meters and also the incoming main. Every meter in this room wasn't bonded within the first (600mm or before the first tee), but on closer inspection it seems they are...
Ch3nKo
Thread
600mm
bonding
building
earth
first
meter
old
seems
within
year
Friends
No longer a bung virgin!
It was a combi / fortic tank.
Wasn't sure but stuck the bung in the only hole I could find.
Turn hot tap on and dribbled.
Undid gate valve and was dribbling but had a mate and swapped it quickly.
No air blocks.
If anyone needs advice on bunging a tank I'm...
Recently our toilet pan is starting to make gurgling and bubbling noises after flushing. When first flushed the water level seems to be initially high before becoming quite low in the u-bend as it completes the cycle. It then starts to gurgle as though it is filling up to the required level in...
Hi,
I have always just trusted my soldering and filled the system slowly and checked each joint visually. I have done a few jobs where I am plumbing refurb from scratch and I am now wondering if I should really buy a wet pressure tester and do a proper test.
I have never really had a problem...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.