Please could anyone advice. I have a 36 y.o. Glow Worm Space Saver 38. I have had it for the last 6 years when bought my current house. I serviced it for the first two years but then stopped servicing in fear that it could be condemned just for being old an inefficient or no spare parts. I did...
Ok sound a bit simple
In my mum's house , need to replace shower bit the shower has been tiled over twice so the screws to get the cover off are covered . Removed a few tiles and want to fit new one on top of tiles but the feed it's too short . Would just cut it and start again but pipe is...
im thinking of replacing my old boiler with a combi in the loft of my bungalow over the bathroom which uses most hot water, but it’s not near a wall, can they be mounted on a wooden frame ?
Hi guys may have job coming up to lower a ceiling but there is a steel gas pipe coming across part of ceiling coming from upstairs to downstairs cooker . Would I be able to leave the pipe above ceiling if vented or have to renew back to meter and bring new pipe down below lowered ceiling ? Thanks
I've seen brown scum in Fe tanks but not this white scum. I would replace tank after PF but what would you guys do? I've had so much trouble with old systems.... Air , noise, pumps failing, scuz playing havoc after drain down...
What's the protocol for whipping Fe out and converting to sealed...
I am currently having my kitchen renovated and the attached pictures shows the wall where we will have the sink run comprising of the following -
Left side - 60cm Dish Washer
Middle - 90cm Sink unit (80cm Sink)
Right Side - 40cm Bin Unit
The whole width of the wall is 205cm
The middle unit...
Hi i'm currently on placement and my engineer's analyser is being re-calibrated and I don't have have any others readings to go of. So if some one could tell me what area of CO,CO2, CO/CO2 and O2 reading you get on balanced flue gas fires. Thanks
Hi,
I'm currently looking to move into a new place near London where the water is awfully hard. I've been recommended to get a water softening unit for my boiler... which one would you recommend?
Thanks,
Cassie
Cassie Bode
Thread
boiler
central heating system
everyone
space
water
which
I'm sure I should know this by now so I apologise in advance for my ignorance but who is DAN, why does he post such wacky random stuff and why does no one ever seem to answer the poor chap?
I'm replacing the PRV on a Worcester 28 CDi, but the space between the red cap and the side of the boiler housing is only about 5mm. The o-ring PRV body is inserted approximately 12mm in to the clipped housing.
Does it slide out when the union is unbolted or is there further dis- assembly...
Hi all,
I would like a exstension along the back of my house. Right in the the middle of the back wall is a foul pipe with a pipe branching into it from my bathroom.
I don't want a column with the foul pipe encased in it n the new kitchen dinner. Are there any other alternatives? Also is there...
Hi all.
I'm putting a new kitchen in my flat and being an old Georgian building nothing is square or level.
I measured the kitchen but obviously didn't allow enough tolerance as my dishwasher is super tight.
The dish washer measures 600mm wide and 550deep.
My void for it is 600mm (so ok)...
Installed hundreds of bogs and never used one but had one on the van for years.
Needed a 90 degree pan con and didn't have one and thought I'd try the swan neck with a straight pushed into it (the custard wouldn't have cared, there were piles of cat turds in the bath and I had to dress up like...
Hi all, i am member of the forum and Gas safe registered.
i just want your opinions on something.
I have spent 20 minutes on the phone to Gloworm on Monday attempting to get some literature for above boiler.
their web site gives no mention to the space saver so no chance of a download.
After...
Hello,
Had a boiler upgrade installed this summer from old gravityfed system to combi boiler (Worcestre Bosch compact). Had boiler relocated to loft. Installer saidit could be done and would meet requirements. Now had GS inspection (really brilliantguy) who checked everything but said that the...
I have what looks like a very old Glow worm spacesaver in my flat (first time buyer) and have suddenly noticed despite not switching the hot water on for weeks the tank stays hot. When i look at the boiler i have noticed the flame is constantly lit, despite turning the hot water tank thermostat...
Chrispee
Thread
constantly
glow
glow worm
glow-worm
heating
hot
hot water
space
water
worm
Hello all,
I am new to this site and have a problem with my boiler.
It is a Glow-worm spacesaver and the problem is this,
when I turn it on the burner ignites and the pump runs.
After a few minutes the burner cuts out on what I think
is the overheat thermostat.
That's it in a nutshell.
Any...
Hi,
I'm looking for the 'perfect' toilet for my new cloakroom, and would appreciate if any pro's can suggest a model.
The one I've seen that is almost perfect is Tavistock Ion Comfort Height Close Coupled.
Spec of that is:
Pan height 460 (high for elderly visitors)
Projection 610 (i.e. short)...
could someone please help me identify this space heater(should be attachment) as i forgot to note down make/model whilst on site doing my gas portfolio.
thanks,
vince
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.