maybe

  1. B

    Kitchen sink not draining, maybe airlocked?

    I am hoping someone can help ... our kitchen sink stopped draining, it looks like an airlock somewhere. This is what I tried: Used chemical drain unblocked and plunger Took everything apart and checked all pipes Bought endoscope and inspected all pipes all the way to 110 soil pipe - all clean...
  2. D

    Vaillant ecoTEC plus 637 with Nest or maybe SensoHome

    Hi, A newbie here but need expert advice, I have installers who have started fitting the boiler (Vaillant ecoTEC plus 637) replacing an old water tank loft system and cylinder in the cupboard I'm also installing a horizontal megaflo (tempest) Okay, so they purchased the Valliant vsmart kit...
  3. P

    Metal "lugs" on old taps (for square holes maybe)? Any problem with removing them?

    Hi all Some old taps have what I'm describing as metal lugs (but just because I can't think of any other word to use!!) like these: Am I right in saying that these are for when fitting to sinks with square tap holes? If so, besides a hacksaw, are there any ways of making these compatible...
  4. holychihuahua

    Hot and cold supply maybe crossed

    Can the cold supply from a loft tank to a cylinder in a basement three floors bellow become heated all the way up to the loft?
  5. M

    Hot radiators remain when heating goes off - maybe from hot water storage cylinder ?

    Hot water coming out of the hot water storage cylinder into upstairs radiators after heating/HW turns off and running out of hot water in the mornings. I have a Glow Worm 24HX Condensing boiler on the ground floor with a pump in the same cupboard, a hot water storage cylinder in the airing...
  6. Nicola84

    Maybe just paranoria

    My boiler always sits at 1 bar however I noticed today it was 0.9, I put it back to 1 then when heating ran it went to 1.3 then back to 1.1 when the heating switched off, I have never monitored the boiler pressure (used to be my husbands job until her ran off with my friend) and now I'm checking...
  7. F

    intergas or viessmann? Maybe something else!?

    So, I need a system boiler. 5 bed, 2 bathroom, 3 underfloor zones(25sq m/26sq m / 12 sqm), 2 radiator zones(upper and lower), hot water(mains pressure 250ltr oso). I was looking at a viessmann, then an ideal gen2, however have been looking into the intergas system boilers. Are they that good...
  8. Bogart

    Simple question? Maybe

    Hope is a simple question. The merits, or not, of deciding which is best as isolation valves for a pair of taps, gate valves , stopcocks or 90degree ballvalves, if any?
  9. townfanjon

    I maybe missing something

    looked at a customers boiler today , shes just moved in and cant figure out the control, me also . Its a logic with a Honeywell programmable stat and a internet stat thing called cosy ( honest ) . Should she have both ? Or am I missing something , can the two be wired together ?
  10. J

    DIY toilet repair - in need of brownie points from the Mrs..

    Hi all, Toilet is leaking when flushed from the toilet to cistern seal and its my job to fix it tomorrow. I'm a graphic designer.... :-/ I know its probably the big rubber seal (spud?) But I don't know what size will fit. I'll have to take it to bits and then take the old seal to the...
  11. J

    Is my UFH broken!

    Hi I moved into a house with UFH installed in one room a few months back. Now the weather is getting cooler I've turned it on for the first time and not convinced its working. When on and room below thermos temp, everything seems to work boiler lights and I can fee the pipes from the manifold...
  12. ShaunCorbs

    (Possible) Enployment Required Maybe

    Looks like the fam business is circling the pan, and hoping to put feelers out to possible employment before it goes **** up Hope i dont but plan for the worst hope for the best Round The Wrexham Area But Willing To Travel A Tiny Bit (30 miles) fully qualified domestic and commercial...
  13. S

    Ideal boiler won't go into central heating mode

    Hi,this is my first post, i have a ideal esprit 2 boiler, the problem started not going into heating mode and hot water was heating flow side for radiators, I jumped the gun I think and changed diverter valve .I realised there could be problem maybe with PCB ? My friend a gas plumber etc said...
  14. S

    Glow worm boiler shutting down

    Hi everyone The boiler fitted is a Glow worm micron, and the system is a standard domestic copper cylinder type, approx 1 year ago the boiler started shutting down maybe once a week, pressing the reset button usually resolved the problem, but recently the boiler has started shutting down every...
  15. C

    Maybe a silly question - replacing a power shower

    Hello My Gainsborough PS1200 has given up the ghost so i'm on the look out for a replacement. This may be a silly question but Do I need to call a plumber, a sparky or ..... both? Cheers
  16. M

    Very little water flow from any ‘hot’ tap in the house

    Very little water flow from any ‘hot’ tap in the house i.e. bath tap, bathroom sink tap and kitchen tap; just a slight flow that stops after a minute or so. Been working fine but virtually stopped flowing this morning. The house has a conventional vented CH system with a cold water storage tank...
  17. P

    Retired to Italy (maybe)

    Ciao everyone, Me and the Mrs are living in Italy for six months over the winter to see if we can fit in with the Italians and the peaceful way of life here in Tuscany. I wasn't intending doing any work but an Italian neighbour has asked me to plumb a new sink in to her washroom. I don't want...
  18. K

    Long shot maybe but worth a read....

    Hi, anyone in the North/North West area willing to take up the offer of free labour in exchange for on site experience? I know there are a billion and one others out there asking and hoping for the same thing. I work hard, I'm not afraid of getting stuck in or heavy work...I even make an awesome...
  19. J

    2 port valve problem maybe?

    2 port valve problem maybe?My Boiler doesn't fire when the hot water is on. If I manually open the 2 port valve the boiler fires for a couple of seconds then shuts off again. Any help would be much appreciated
  20. U

    2 port valve problem maybe?

    My Boiler doesn't fire when the hot water is on. If I manually open the 2 port valve the boiler fires for a couple of seconds then shuts off again. Any help would be much appreciated
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock