Currently reading:
Calculating pipe centres

Discuss Calculating pipe centres in the Water Underfloor Heating Advice area at PlumbersForums.net

Messages
3
Similar to radiator dT's, is there a way to mathematically calculate the UFH pipe centres required to satisfy a given room's heat demands?

150mm-250mm centres are banded about online, with no real explanation, obviously smaller centres allow for lower water temps, but there must be a more scientific way on deciding the centres for a given scenario?
 
Tbh you can work it out eg via cibse ufh guide or via a paid software but I normally go 100mm centres and work out the flow rate etc eg 1kw needs 2.04 lpm
 

Reply to Calculating pipe centres in the Water Underfloor Heating Advice area at PlumbersForums.net

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock